ADD ON SENSOR KITS:

Level 1 Sensor Kit

Level 2 Sensor Kit

BASE KIT INCLUDES:

• Motec M130 or M150 ECU
• Custom firmware
• Fully populated patch loom to suit engine: All spare inputs and outputs are on the break out connector. This means you don’t have to hack into the patch loom when adding sensors and CAN devices
• Base map. This will have your car up and running in minutes.
• Wiring pin out diagram for patch loom and expansion connector.
• 4 bar map sensor
• Inlet air temp sensor

FEATURES

• Cruise control
• Rolling Launch Control
• Direct Keypad Integration
• Analogue Wide-band Input
• CAN Bus Integration for most common EGT boxes
• Water Injection Control
• Bosch ABS M4 & M5 Integration
• Engine Start/Stop Control
• Additional Sensor Input Channels
• Improved CAN Message Outputs
• Improved Gear Estimation Calculations
• In-Built ATTESA control
• MFD Display works as factory
• Many More!